Feature
- Plug-on adapter for decoupling a CAN bus for LIKE CAN interfaces
- Galvanic isolation by DC/DC converters up to 1000 V
- Bit rates up to 1 Mbit/s
- High-speed CAN transceiver NXP PCA82C251
- CAN bus connection via D-Sub, 9-pin (in accordance with CiA® 102)
- LED for status indication of the supply voltage
- 120 Ohm bus termination
- Power supply (5 V) through pin 1 of the High-speed CAN connection. Nearly all CAN interfaces by LIKE Electronics Technology can provide the required supply
- Extended operating temperature range from -40 to 85 °C (-40 to 185 °F)
Overview
The LCAN-Optoadapter is a universal plug-on adapter to allow galvanic isolation of High-speed CAN bus systems.
Its integrated logic means that decoupling can be installed at any point in the CAN network.
CAN1 Port
Connector Type: Female D-Sub Connector(in accordance with CiA® 102)
Signal Support: 1- 5V Power supply. 2- CAN-L. 3- GND. 4- Not connected. 5- Not connected. 6- GND. 7- CAN-H. 8- Not connected. 9- Not connected.
Isolation Protection: 1KV
Termination Resistor: Dip switch selector for 120 Ω terminal resistor.
CAN2 Port
Connector Type: Male D-Sub Connector(in accordance with CiA® 102)
Signal Support: 1- Not connected. 2- CAN-L. 3- GND. 4- Not connected. 5- Not connected. 6- GND. 7- CAN-H. 8- Not connected. 9- Not connected.
Isolation Protection: 1KV
Termination Resistor: Dip switch selector for 120 Ω terminal resistor.
Physical Characteristics
Dimensions: 63 x 34 x 17 mm
Environmental Limits
Operating Temperature: -40 to 85°C (-40 to 185°F)
Ambient Relative Humidity: 5 to 95% (non-condensing)
Power Requirements
Input Voltage: +4.5V～+5.5V DC power inputs
Power Consumption: 50 mA @ 5 V
